How to Install LED Solar Street Light

LED solar street light  radiation as an energy source during the day using solar panels converting solar energy to charge the battery, the battery at night to power the LED light source lighting, without complex and expensive pipeline laying, the layout can be adjusted lighting, security, clean energy, no manual work is stable and reliable, saving electricity maintenance-free. So how to install solar street lights it?

1) After the pole is installed, start all components (solar panel, battery, light source) of the wires to the controller. (See specific controller wiring diagram)

2) The wires of the first light source directly connected to the battery wires to see if the light source, the light source may determine the positive and negative wires (positive and negative reversed light after the lamp is not lit, will not damage the light source can be Rest assured lamp test), then the positive wire is connected to the light source has a light bulb icon on the corresponding red, the negative electrode is connected to the light source has a light bulb icon corresponding to the black line on the controller on the controller.

3). DC voltage profile with a multi meter to check out the positive and negative battery outlet, the battery is connected to the positive wire will have the battery icon corresponding to the red line on the controller, the battery will have a negative wire to the battery on the corresponding controller black line.

4). DC voltage profile with a multi meter to check out the solar panel outlet positive and negative, the positive wire is connected to the solar panels have solar panels on the icon corresponding to the red line on the controller, the negative wire is connected to the solar panel on the controller there are solar panels corresponding black lines.

5). When the controller has been factory programmed to debug and intelligent lighting time, after the wiring does not need to debug the controller, the controller will automatically enter the working state.

6) Note: Tighten the screws when the battery box is installed, as well as water threading pipe, water pipe threading into the base of the pole to 20 cm above the ground, to ensure that the flooding rain will not over-water pole flange to the battery box. Additionally, the installation select a location to avoid obstruction of the solar panels, the solar panels can’t avoid contact with the sample can’t be charged.